bullet runout

[josebd2006]

whats the best way to get .003 or less?i use forster fl die and forster micro bullet seater,rcbs press

[Lee C.]

I've got the rcbs case master gaging tool. And used it after each step as i went. To fine where my run out was comeing from first. And as i got better die's and stell had some run out. I found it comeing from my rcbs press. As when the press was all the way up the shaft would move some. But about all you can do is fine where it is comeing from and fix what ever is doing it.

[Bumshot]

I always seat the bullets, then give the case a half turn and seat them again. That will cut down the run out.