Turn ur neck

[brokeasajoke]

How important do you guys feel turning your necks is or trueing the outside of the necks to put it another way?

[acloco]

Depends on how much the thickness of the brass varies on the neck and how straight/tight the neck in the chamber is.

I prefer to turn mine. I would prefer to NOT turn necks, but, just a light cut will help.

[Lee C.]

I think it's important even for a factory chamber. But you don't wan't to cut them any more than you need. As a factory chamber is a little over size to start with. I clean up the neck with the first cutting. Then load them up and shoot it, then make my last cut on the neck so i get the same thickness all around the neck.
this gives me nice even tension on my bullet and helps keep it straight when release from the case. I hope this helps you to under stand it alittle better any ways. Lee