Turn ur neck
-
- Junior Member
- Posts: 96
- Joined: Thu Mar 16, 2006 10:20 pm
- .204 Ruger Guns: Rem VSSF II .204 VX-III 8.5-25 side focus tgt dot
- Location: Western N. Carolina
- Contact:
Turn ur neck
How important do you guys feel turning your necks is or trueing the outside of the necks to put it another way?
-
- Senior Member
- Posts: 1708
- Joined: Mon Sep 25, 2006 8:53 pm
- .204 Ruger Guns: 12FV, 12BVSS -S
- Location: Nebraska
Re: Turn ur neck
Depends on how much the thickness of the brass varies on the neck and how straight/tight the neck in the chamber is.
I prefer to turn mine. I would prefer to NOT turn necks, but, just a light cut will help.
I prefer to turn mine. I would prefer to NOT turn necks, but, just a light cut will help.
-
- Senior Member
- Posts: 356
- Joined: Fri Apr 21, 2006 12:00 am
- Location: antigo wisconsin
- Contact:
Re: Turn ur neck
I think it's important even for a factory chamber. But you don't wan't to cut them any more than you need. As a factory chamber is a little over size to start with. I clean up the neck with the first cutting. Then load them up and shoot it, then make my last cut on the neck so i get the same thickness all around the neck.
this gives me nice even tension on my bullet and helps keep it straight when release from the case. I hope this helps you to under stand it alittle better any ways. Lee
this gives me nice even tension on my bullet and helps keep it straight when release from the case. I hope this helps you to under stand it alittle better any ways. Lee