MidSouth's 34 grain Varmint Nightmare Bullet

Experiences and effectiveness in hunting with the 204 Ruger.
graymist
New Member
Posts: 10
Joined: Tue Mar 15, 2005 7:53 pm
Location: Florida & Ohio
Contact:

MidSouth's 34 grain Varmint Nightmare Bullet

Post by graymist »

Spent the past week in Ohio shooting my favorite varmints, groundhogs, with the MidSouth 34 grain Varmint Nightmare Bullet.

After spending considerable time last year working up a load for this bullet in the Encore this trip was to be the test for the bullets effectiveness on groundhogs. On small groundhogs I had exit wounds on all hits. Generally 1.25 to 1.5 inch hole on the far side of the groundhog. On larger groundhogs bullets did not exit, unless a shoulder was hit and then it was secondary fragments. Except for a twitching tail no groundhogs moved after hit with this bullet. I had no shots over 160 yards due to terrain in the hilly area I was hunting so I cannot comment on the long range effectiveness of the bullet. For eastern hunting on groundhogs it proved a good bullet that I will use again.
Ethan
New Member
Posts: 29
Joined: Fri Dec 23, 2005 8:04 am
.204 Ruger Guns: T/C Encore
Location: Mid Michigan

Re: MidSouth's 34 grain Varmint Nightmare Bullet

Post by Ethan »

what load did you settle on? I have decent accuracy from mine with 28 grains of 4895.
graymist
New Member
Posts: 10
Joined: Tue Mar 15, 2005 7:53 pm
Location: Florida & Ohio
Contact:

Re: MidSouth's 34 grain Varmint Nightmare Bullet

Post by graymist »

27.9 of H4895, Winchester brass, Remington 7.5 primer.
Ethan
New Member
Posts: 29
Joined: Fri Dec 23, 2005 8:04 am
.204 Ruger Guns: T/C Encore
Location: Mid Michigan

Re: MidSouth's 34 grain Varmint Nightmare Bullet

Post by Ethan »

almost the same load. I am using Win cases and Rem primers too.
Post Reply