44 mag seating ?
44 mag seating ?
When seating my bullets I am getting as much as 10 thousands difference in col. I am using a lee press and hornady dies. These rounds are my plinker rounds of 7 grains of titegroup and 240-grain hornady swc. Brass is all trimmed the same size. These are 44 mag rounds and I know that the difference will not matter much in my shooting but it bothers me as to why the difference. Any and all ideas are very much appreciated.
Sportingly
cracker
-
- Senior Member
- Posts: 1708
- Joined: Mon Sep 25, 2006 8:53 pm
- .204 Ruger Guns: 12FV, 12BVSS -S
- Location: Nebraska
Re: 44 mag seating ?
Have you measured/compared bullets? As long as you are crimping at the same spot in the cannelure, I would not worry about it.