What Primers

[skipper]

Check the Midway site again. It says "Out of Stock,No Backorder". If you can still find it I would grab as much as you can.

The dies you have may do the job. I would load a few and see how they turn out. Check the run out to see if they will produce acceptable loads.

If you go the custom die route. I would get a Body Die for sizing new brass and bumping the shoulders back. A Bushing Neck Sizing Die for sizing your case necks between firings and a Micrometer Top Seating Die. Like jo191145 said, if you can get a hold of the reamer used on your chamber, that would make it possible to have dies made that perfectly match your rifle.

[LeeC]

For hard to find brass and dies, you might try huntingtons.com.

[augnmike]

Brass is available from Midsouth. I have 500 rounds now and could order more but I don't know how much I will need. Once this rifle is sighted in it will strictly be for predators. I have a blueprint for the build so the exact dimensions are on there. I could have Redding build me a set of dies off of the blueprint I guess.

Lee thanks for the tip.

[Silverfox]

Sorry to hijack the thread, but it will only be for a little bit I have 368 brand new .222 Remington Magnum casings by Remington that I would be happy to supply to any interested party for $75--shipping included. That's just a tish over 20¢ per casing with shipping. I you are interested e-mail me at: