Question for barrel swappers

BSmith · Post by **BSmith** » Fri Apr 27, 2007 7:29 am

In researching how to do a Savage barrel swap, I've seen several people mention "remote firing" of the completed rifle. Do any of you do that? I've done it with an old Ithaca .22, tied it in a fork of a tree and used a string to pull the trigger. I don't have a big sled rest that can handle a centerfire rifle. The weight of the VLP .204 results in almost no recoil but when I get the .243* and .308* barrels, that will change.

Bottom line: is doing a careful job good enough?

*I know that Savage doesn't make a model 12 VLP in .243 and .308 but the barrels are available elsewhere.

Thanks!

Hotshot · Post by **Hotshot** » Fri Apr 27, 2007 2:28 pm

I am very carefull-double and tripple check everything. I test with a known mild pressure round and I hold the rifle but don't put my head on the stock, just kind of hip fire.

22shooter · Post by **22shooter** » Sat Apr 28, 2007 6:11 am

The best safety items when chaning a barrel on a Savage rifle is the go and no-go gauges. If the bolt closes on a go gauge and doesn't close on a no-go gauge then you have the head spacing correct.

The Savage system with the barrel nut is a gret idea. It allows a lot of configuring. I have 4 savage actions and so far 6 barrels. the barrels are:
.223 Rem hunting
.223 Rem Varmit barrel
.204 Ruger Stainless Steel Fluted Varmit
.243 Win
.260 Rem
.308 Win

I intend to get a .338 Federal barrel.

glenn asher · Post by **glenn asher** » Sat Apr 28, 2007 6:43 am

I have a buddy with all the stuff, already paid for, so I let him do the swaps for me

. He uses the go-no go gauges, so there's really little to chance. Hasn't messed anything up yet, anyway

He's done a LOT of swapping for himself and his friends, and all of us have our fingers, toes and eyes, he must do a good enough job. I don't have any concerns when Steve's been at the rifle. I've seen him do it enough that I know how, but since he's got a nice shop, I'd rather drive over and let him tinker while we visit. He's got a nice range, too........

BSmith · Post by **BSmith** » Sat Apr 28, 2007 8:23 am

Thanks for the responses. I'm going to have to find a "Steve" up here somewhere. I can't wait for all the parts to get here.

Hotshot · Post by **Hotshot** » Sat Apr 28, 2007 10:37 am

BS,

The current Varmint Hunter Magazine has an article submitted by a member who describes his learning experience installing Savage barrels. Might be worth a look to ya.

22shooter · Post by **22shooter** » Mon Jul 16, 2007 6:12 am

Go to http://www.savageshooters.com/ They have all the information that you will need to change a Savage barrel along with recommendations on the needed equipment.