VLP barrel finally broke in
Posted: Sun Mar 25, 2007 6:44 pm
It took about 120 rds but I think my barrel is finally broke in. I shot this group on saturday: 26.8gr H335 in new Winchester brass w/ BR-4 primers and the 39gr Sierra BK.
All five shots basically went in the same hole. The target was taped to some particle board so it tore up the paper quite a bit. Sorry about the picture quality but all I had was my phone. I had several other groups that were within 1moa. I'm looking for a load I can mass produce for prairie dogs. I've had some sucess with BL-C(2) also. This was the first day I could really shoot a group with this rifle. The height of the white stripe is one inch.
The crossed off shots are from my 22LR.
I also had a reloading question as I've only shot new brass so far. I have a full-length sizer die but have only sized the necks on the new brass. Do most reloaders bump the shoulder back some or is it okay to leave it where it's at so it fits my chamber. Any advice would be greatly appreciated.
Casey
All five shots basically went in the same hole. The target was taped to some particle board so it tore up the paper quite a bit. Sorry about the picture quality but all I had was my phone. I had several other groups that were within 1moa. I'm looking for a load I can mass produce for prairie dogs. I've had some sucess with BL-C(2) also. This was the first day I could really shoot a group with this rifle. The height of the white stripe is one inch.
The crossed off shots are from my 22LR.
I also had a reloading question as I've only shot new brass so far. I have a full-length sizer die but have only sized the necks on the new brass. Do most reloaders bump the shoulder back some or is it okay to leave it where it's at so it fits my chamber. Any advice would be greatly appreciated.
Casey