case trimmer for diff rounds

Share information about reloading the 204 Ruger.
kevinsulikowski
New Member
Posts: 6
Joined: Thu Jan 04, 2007 7:21 pm
Location: chicopee ma

case trimmer for diff rounds

Post by kevinsulikowski »

is there a way to to mark the case trimmer to do diff rounds. i reload for my 308 and now for my 204 just was wondering it there was some good way to mark the trimmer to get it back to almost the same spot or would it be better to set up two trimmers. or buy another trimmer shaft and have a shaft for each round ? just looking to see what most people do.
User avatar
Rick in Oregon
Moderator
Posts: 4942
Joined: Thu Dec 01, 2005 4:20 pm
.204 Ruger Guns: Sako 75V, Cooper MTV, Kimber 84M, Cust M700 11 Twist
Location: High Desert of Central Oregon
Contact:

Post by Rick in Oregon »

Don't buy two trimmers. Just have a dummy or sample case for every round you want to process, trimmed to the exact length you're after.

Put the sample case in the trimmer, lock shaft's length adjustment screw for that case, and you're done. All the cases trimmed will be the exact length of the dummy round.

Verify the length dimension with a good set of dial or digital calipers just to make sure.
Semper Fortis
Rick in Oregon
NRA Life/OHA/VHA/VVA

Oregon, East of the Cascades - Where Common Sense Still Prevails

Image
faucettb
New Member
Posts: 28
Joined: Thu Feb 17, 2005 3:17 am
Location: Northern Idaho

Post by faucettb »

Buy a Lee trimmer for both of them. No fuss, no muss and you can't make a mistake.
Bob from Idaho
acloco
Senior Member
Posts: 1708
Joined: Mon Sep 25, 2006 8:53 pm
.204 Ruger Guns: 12FV, 12BVSS -S
Location: Nebraska

Post by acloco »

faucettb wrote:Buy a Lee trimmer for both of them. No fuss, no muss and you can't make a mistake.
Lee does not make trimmers below 22 caliber. :(
Post Reply