40 grain Berger stabilization

Share information about reloading the 204 Ruger.
crazyyote
New Member
Posts: 13
Joined: Sat Dec 07, 2019 8:03 am
.204 Ruger Guns: ar15

40 grain Berger stabilization

Post by crazyyote »

Does anyone here have any firsthand experience using the 40 grain Berger BTHP #20304 in a 1-11 twist barrel? Berger's charts show this to be marginally stable, with about 94-96% stability depending on the velocity, etc. I have a 22" 1-11 twist AR barrel that I plan to install by this fall for hunting. I know a 1-10 twist would have been better but I didn't look that for before placing the order. Thanks.
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: 40 grain Berger stabilization

Post by Bill K »

I shoot very few of the 40 grain. Mostly use the 32 & 39 grain bullets in my 20's. but the 40's I have shot in the 1/11 twist barrels I have shot okay. Some, mostly in the 1/12 twist don't have such good results, where as the 39 grain one's will stabilize. You should be fine in your 1/11 twist, but only your rifle will tell you if it is so. Bill K
User avatar
Rick in Oregon
Moderator
Posts: 4942
Joined: Thu Dec 01, 2005 4:20 pm
.204 Ruger Guns: Sako 75V, Cooper MTV, Kimber 84M, Cust M700 11 Twist
Location: High Desert of Central Oregon
Contact:

Re: 40 grain Berger stabilization

Post by Rick in Oregon »

I'm running an 11T Pac-Nor in my 204 Ruger Match chamber, and the 40's all stabilize well, no matter what brand of bullet. The 39gr SBK shoots lights out in this one!

Virtually all my shooting is 'rat shooting', so I do not use Bergers....needlessly expensive for blowing up grass rats. :wink:
Semper Fortis
Rick in Oregon
NRA Life/OHA/VHA/VVA

Oregon, East of the Cascades - Where Common Sense Still Prevails

Image
crazyyote
New Member
Posts: 13
Joined: Sat Dec 07, 2019 8:03 am
.204 Ruger Guns: ar15

Re: 40 grain Berger stabilization

Post by crazyyote »

Thanks!!!. I'll rest easier knowing I didn't screw it up. I got the same reassurance over at Saubier.com
Gube
Senior Member
Posts: 477
Joined: Tue May 23, 2006 11:03 am
.204 Ruger Guns: Savage VLP and BTVSS. Tikka 3 stainless & grey laminate
Location: Ft. Sask, Alberta

Re: 40 grain Berger stabilization

Post by Gube »

I use 24.5 gr RL-10X and 25.5 gr of H-4895 for 40 gr Berger’s. Not quite as accurate as the 35 gr Berger’s though. These are with 3, 12 twist tubes so you should have no problem with a 11 twist.
Savage Vaporizer
Image
User avatar
DoubleUp
Senior Member
Posts: 146
Joined: Tue Dec 21, 2010 5:36 pm
.204 Ruger Guns: 204 Ruger

Re: 40 grain Berger stabilization

Post by DoubleUp »

When I was shooting the 204 a lot, I had very good results on paper with the 40 Bergers over 27.6 grs. of 8208 in two different 204's. Also very good results with AR-Comp at 27.2 grs. Both ran about 3,750 fps. Although I shot quite a few coyotes with the 35 Berger with excellent results, I never used the 40's on coyotes but thought they should work well. I was able to stabilize the 40's in 2 different rifles with 12 twist barrels at sea level. These loads were safe in my rifles but I make no claims as to how safe they are for anyone else.
varmit_master
Junior Member
Posts: 93
Joined: Mon May 06, 2013 4:30 am
.204 Ruger Guns: TC 204
Location: Arkansas

Re: 40 grain Berger stabilization

Post by varmit_master »

I have a tc venture 204 predator model. Its a 1@10 it shoots the h4895 and 40gr very well.
Post Reply