SmallCaliberCentral

So I am new to reloading, and could use some help with selecting a good die setup.Does anyone use the Redding Premium Series Deluxe 3 die set? It appears to have all you need as far as precision adjustments go. I have the RCBS FL 2 die kit, but it takes a lot of measuring to keep up with different loads. IF these are not the ticket, any other suggestions would be appreciated.
Thanks.

to give you more flexibility down the road i would recommend a set of bushing dies. This will allow you to change neck tension if you switch from one brand of brass to another as well as extend the brass life by not overworking it. If you want the best die set available on the market check out my friends at Whiddens Gunworks. http://www.whiddengunworks.com/product/ ... die-set-2/
Whidden's has a 2 die set consisting of a full length bushing die and a micrometer top seat die that will do everything you could ever need for the 204 ruger.

I think Brad nailed it for you.

1. Redding or Whidden, can't go wrong with either.
2. Bushing type sizer. From Redding, it would be the Type-S.
3. Micrometer top seating die.

You can save time adjusting the seating die you already have by saving a dummy round with each type of bullet you use. Back the stem out, run the dummy into the die and turn the stem back in (down) until it contacts the bullet and lock it in place. Not as precise as the micrometer but, may save some frustration in the meantime.

Bonanza/Forester dies are good ones too. I'd get the one where the replacement parts can be readily obtained if something goes wrong [bent spindle, decap pin,...etc].

I have a set of Forster dies for my 204, with micrometer seating die. I have bent the deprimer spindle twice now. I am waiting for my Redding full length bushing die and bushing to arrive now. I too have had great luck with Redding type S bushing dies. Brownells had them in stock a few days ago. I had a difficult time finding a place that had the die and bushing in stock. I ordered a .227 bushing, same as the one on my 20 VarTarg dies. Ramos gave you good advise to make a dummy round, no primer, no powder once you have established the best seating depth for your rifle. Happy shooting!