Re: Advice needed please....
Posted: Mon Nov 26, 2012 7:54 am
Hello again folks.
Thanks for the replies.
I've just noticed something different about my Sierra Blitzking bullets in my reloads, compared to my Remington 32 grain Accutip-v and Hornady Superformance 24 grain NTX factory round bullet heads.
There is no gap at all between the polymer tip and the copper jacket on either the Remington or Hornady bullet heads on my factory rounds. Yet there is a noticable gap on all the Sierra Blitzking rounds.
Is this usual, or have i got a bad batch? If it's normal, is the gap the likely cause of the heads being the less accurate??
Thanks for the replies.
I've just noticed something different about my Sierra Blitzking bullets in my reloads, compared to my Remington 32 grain Accutip-v and Hornady Superformance 24 grain NTX factory round bullet heads.
There is no gap at all between the polymer tip and the copper jacket on either the Remington or Hornady bullet heads on my factory rounds. Yet there is a noticable gap on all the Sierra Blitzking rounds.
Is this usual, or have i got a bad batch? If it's normal, is the gap the likely cause of the heads being the less accurate??