Bought Remington small rifle 6.5 primers by accident..

Share information about reloading the 204 Ruger.
Killymagee
New Member
Posts: 6
Joined: Sun Nov 27, 2011 8:21 pm
.204 Ruger Guns: Savage 12 FLV

Bought Remington small rifle 6.5 primers by accident..

Post by Killymagee »

Ok, so as the title says, I loaded up 6 and a half remington primers with my usual load of 25 grains of benchmark with 40 grain Vmax bullets. I usually use 7.5 but bought 6.5 by accident and just realized this now.... Will this work ok?, or do I have to chuck them out?, will it hang fire on me?.
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Bought Remington small rifle 6.5 primers by accident..

Post by Bill K »

I doubt you would get a hangfire. You might find that the primer, being a thinner cup, will pierce. It should hurt nothing to fire a couple of rounds, with your load, see how it groups and if the primer holds. If you do not want to check that out, see if someone in your area will buy them or use them in one of your other lower intensity cartridges. Bill K
User avatar
wirelessguy2005
Senior Member
Posts: 663
Joined: Wed Feb 24, 2010 6:59 pm
.204 Ruger Guns: Custom 20 SCC, Savage LRPV 20 Nitro , Howa 1500 204 Ruger
Location: Indiana

Re: Bought Remington small rifle 6.5 primers by accident..

Post by wirelessguy2005 »

due to the 6.5 having a thin cup I would be more concerned about piercing a primer due to pressure levels in the 204. I think you are best off removing the 6.5 primers and replacing them with 7 1/2 or comparable primers. Just my 2 cents.
Killymagee
New Member
Posts: 6
Joined: Sun Nov 27, 2011 8:21 pm
.204 Ruger Guns: Savage 12 FLV

Re: Bought Remington small rifle 6.5 primers by accident..

Post by Killymagee »

Ok, thanks guys, I will do that. The firing pin on my Savage 12 FLV hits the primers a little too hard so I have rings around my primers so I think I'm gonna dump the shells loaded with the 6.5's. Can't wait to go this weekend and shoot more Pdogs with some .204's soo much fun!.
broper
Senior Member
Posts: 318
Joined: Tue Jan 06, 2009 4:12 pm
.204 Ruger Guns: Remington 700 sps
Location: Parma, Idaho

Re: Bought Remington small rifle 6.5 primers by accident..

Post by broper »

I've been using Rem. 6 1/2 primers im my .204 with no problem. Used with 32 gr. Varmageddons and 39 gr. Speer both and 30 gr. BLC(2). The 32 gr. Varmageddon is super accurate with one three shot going into .168. As I said, I've had no problems with the 6 1/2's and think I'll continue using them.
User avatar
wirelessguy2005
Senior Member
Posts: 663
Joined: Wed Feb 24, 2010 6:59 pm
.204 Ruger Guns: Custom 20 SCC, Savage LRPV 20 Nitro , Howa 1500 204 Ruger
Location: Indiana

Re: Bought Remington small rifle 6.5 primers by accident..

Post by wirelessguy2005 »

While it may be possible to use Rem 6 1/2 primers with the 204 it is not recommended by the manufacturer or any of the reloading manuals. The Remington 6 1/2 primers were originally designed for the 22 Hornet as well as other low pressure type cartridges. A few months back i was reloading a 17 Hornady Hornet with 6 1/2 primers, even with the charge well off max the primers were piercing. The 17 HH operates at pressures well under that of the 204 ruger.
acloco
Senior Member
Posts: 1708
Joined: Mon Sep 25, 2006 8:53 pm
.204 Ruger Guns: 12FV, 12BVSS -S
Location: Nebraska

Re: Bought Remington small rifle 6.5 primers by accident..

Post by acloco »

Do NOT use Rem 6.5 primers in high pressure rounds (17 Rem and above). These are manufactured for low pressure rounds like 22 Hornet, etc.

You WILL experience a blown primer. You WILL have metal particles exiting the vent in the side of your action. Your firing pin and bolt face will be torched by the hot gas exiting the blown primer.
Ol` Joe
Junior Member
Posts: 74
Joined: Thu Dec 08, 2011 8:12 am
.204 Ruger Guns: Remington XR-100

Re: Bought Remington small rifle 6.5 primers by accident..

Post by Ol` Joe »

acloco wrote:Do NOT use Rem 6.5 primers in high pressure rounds (17 Rem and above). These are manufactured for low pressure rounds like 22 Hornet, etc.

You WILL experience a blown primer. You WILL have metal particles exiting the vent in the side of your action. Your firing pin and bolt face will be torched by the hot gas exiting the blown primer.

This!
Post Reply