once fired brass wont chamber????????????

Share information about reloading the 204 Ruger.
skipper
Moderator
Posts: 1404
Joined: Thu Feb 09, 2006 3:32 am
.204 Ruger Guns: Remington XR 100, Custom build Lilja/Panda/Shehane/Jewell
Location: Cypress, TX

Post by skipper »

Vartarg

Try sizing one case without the expander ball. Then try to seat a bullet in the case. I believe you will find you don't actually need the expander ball. If you do you can just run the case back through the die with the expander. Remember to chamfer or you'll strip jacket material off when you seat the bullet.
Image Hold 'em & Squeeze 'em
.204 Sniper
Junior Member
Posts: 82
Joined: Wed Jul 11, 2007 4:01 pm
Location: Reno, Nevada

Post by .204 Sniper »

:offtopic: Sorry!

The Lee factory Crimp Die is giving me Extreme Spreads of 3-4 fps. I weigh every charge - EXACTLY. I weight sort my cases (after prep).
I was getting 15-20 fps ES before I tried the Factory Crimp Die.
When your attack is going well you are about to be ambushed.
Post Reply