Monthly Shootout: September 2017!!!

Participate in friendly board-wide competitions.
User avatar
brooksb
Senior Member
Posts: 181
Joined: Thu Sep 08, 2016 3:34 pm
.204 Ruger Guns: Ruger M12 FV
Location: up date, we sold in Ca, we are house hunting.

Re: Monthly Shootout: September 2017!!!

Post by brooksb »

the mic on the first pic seems to indicate you're not measuring center to Center? cause that is the standard, no sense handicapping oneself. If not I measure two or three ways to keep me honest, and compare, Center to center, outside of one to inside of the other and/or outside to outside then subtract one bullet diameter. All depends on the condition of paper.
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Monthly Shootout: September 2017!!!

Post by Bill K »

I may be wrong, but I believe for the monthly shoot, outside to outside is what we are too measure. With no deduction for bullet diameter, as you would if you measure outside to outside other times.
When measuring center to center, then you do not deduct the bullet diameter, so I have been told.
Maybe someone should really clarify this, before we get too far into this monthly shoot. Bill K
User avatar
brooksb
Senior Member
Posts: 181
Joined: Thu Sep 08, 2016 3:34 pm
.204 Ruger Guns: Ruger M12 FV
Location: up date, we sold in Ca, we are house hunting.

Re: Monthly Shootout: September 2017!!!

Post by brooksb »

my mistake, I wasn't around much to participate in the competition, always figured C to C was std.
HoundofSC
Junior Member
Posts: 82
Joined: Thu Jan 26, 2012 4:36 pm
.204 Ruger Guns: Stevens based custom

Re: Monthly Shootout: September 2017!!!

Post by HoundofSC »

I have never used anything except C to C, but can change if that is what it is
53eldorado
New Member
Posts: 43
Joined: Tue Dec 03, 2013 6:54 pm
.204 Ruger Guns: Ruger American Predator
Location: Colorado

Re: Monthly Shootout: September 2017!!!

Post by 53eldorado »

I was going for C to C too. What I read in another forum was to measure outside to outside and subtract bullet diameter so for the group measurement of 1.150 minus .204 = .946.

For C of bull to C of hole for the far shot I subtracted half of bullet diameter. 1.131 - .102 = 1.229
53eldorado
New Member
Posts: 43
Joined: Tue Dec 03, 2013 6:54 pm
.204 Ruger Guns: Ruger American Predator
Location: Colorado

Re: Monthly Shootout: September 2017!!!

Post by 53eldorado »

Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Monthly Shootout: September 2017!!!

Post by Bill K »

That has what has reared it's head, which way to score the target for this shoot. The previous challenge was center to center, with no bullet deduction. So that would be a good way to do it.
But if some or the moderator on this monthly shoot wants outside to outside, with deduction, okay. We just need to know, for sure, which way. I really could not see which way was correct from the original post re: the monthly shoot.
It needs spelled out, at least for this old man and simple mind.. Bill K
Hyper
New Member
Posts: 13
Joined: Mon Sep 05, 2016 3:28 am
.204 Ruger Guns: savage 12 ,Bell and Carlson stock,McGowen 1n11 twist barrel.
Location: Minnesota

Re: Monthly Shootout: September 2017!!!

Post by Hyper »

Am I to assume that using MOA calculator can not be used?
HoundofSC
Junior Member
Posts: 82
Joined: Thu Jan 26, 2012 4:36 pm
.204 Ruger Guns: Stevens based custom

Re: Monthly Shootout: September 2017!!!

Post by HoundofSC »

everything you ever wanted to know about shooting groups and analyzing them

https://www.ar15.com/forums/ar-15/-/118-279218/?
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Monthly Shootout: September 2017!!!

Post by Bill K »

This is getting out of hand. All we need to know is how everyone is going to measure and targets. either center to center or outside to outside. Then we all can use the same system and have fun and not make it complicated. Bill K
skipper
Moderator
Posts: 1404
Joined: Thu Feb 09, 2006 3:32 am
.204 Ruger Guns: Remington XR 100, Custom build Lilja/Panda/Shehane/Jewell
Location: Cypress, TX

Re: Monthly Shootout: September 2017!!!

Post by skipper »

Bill K wrote: Mon Sep 18, 2017 7:09 am This is getting out of hand. All we need to know is how everyone is going to measure and targets. either center to center or outside to outside. Then we all can use the same system and have fun and not make it complicated. Bill K
Check out the post on measuring group size. It may help.
Image Hold 'em & Squeeze 'em
HoundofSC
Junior Member
Posts: 82
Joined: Thu Jan 26, 2012 4:36 pm
.204 Ruger Guns: Stevens based custom

Re: Monthly Shootout: September 2017!!!

Post by HoundofSC »

skipper wrote: Mon Sep 18, 2017 7:32 am
Check out the post on measuring group size. It may help.

from post #1
Score your group in inches. Then measure distance from bulls-eye to your furthest shot. Add these two. That is your score for that target.
nothing about whether the group size is measured center to center or edge to edge even whether to go edge to edge on farthest on the bull to farthest shot.

I will do it however you guys want, however the rules on measuring need to be clarified so that we are all on the same system
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Monthly Shootout: September 2017!!!

Post by Bill K »

Until told otherwise, I am measuring outside to outside, with no deduction for caliber. group size, then a measurement for farthest, from center, then a total. Hope all other's do the same unless we are told otherwise. Bill K
HoundofSC
Junior Member
Posts: 82
Joined: Thu Jan 26, 2012 4:36 pm
.204 Ruger Guns: Stevens based custom

Re: Monthly Shootout: September 2017!!!

Post by HoundofSC »

Bill K wrote: Mon Sep 18, 2017 8:03 am Until told otherwise, I am measuring outside to outside, with no deduction for caliber. group size, then a measurement for farthest, from center, then a total. Hope all other's do the same unless we are told otherwise. Bill K
as long as all are doing the same that should not be a issue, but honestly I cannot think of any rifle competition that does it that way. In this case it does not matter one way or the other since we are all shooting .20 cals

Jax just needs to set the standard

heck , when I do my shooting this week I will post the target using both methods if no standard has been set
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Monthly Shootout: September 2017!!!

Post by Bill K »

[q Check out the post on measuring group size. It may help.
[/quote]

Which one Skipper ? I thought we were going to measure outside to outside, etc. as you had us do with the 204 challenge, then this center to center/deduct style came up. I agree Jax needs to advise which method we will use in this monthly fun shoot. Bill K :)
Post Reply