Page 1 of 1
I will be getting my new Remington XR-100 next week...
Posted: Fri Sep 12, 2008 3:10 pm
by 6.5x61Super
any thoughts, opinions, favorite reload, etc...on the rifle??
thanks.
Re: I will be getting my new Remington XR-100 next week...
Posted: Fri Sep 12, 2008 5:53 pm
by Ruger No. 1
Rem 7.5 primer
39 gr sierra
25.2 grains H4895
Thats my favorite load for mine.
Re: I will be getting my new Remington XR-100 next week...
Posted: Fri Sep 12, 2008 6:02 pm
by greystone
Looks good! I'd be interested in how it shoots for you. I like those Remingtons. Dave
Re: I will be getting my new Remington XR-100 next week...
Posted: Fri Sep 12, 2008 6:52 pm
by Captqc
Livetohunt, welcome to the forum! You'll find lots of great guys and tons helpful information here. When you get your new rifle don't forget to post some pics. Gary
Re: I will be getting my new Remington XR-100 next week...
Posted: Sat Sep 13, 2008 4:40 am
by Glen
Welcome to the Forum!!
Congratulations on the new rig too.
My only opinion is to start low & work up.
Re: I will be getting my new Remington XR-100 next week...
Posted: Sat Sep 13, 2008 12:19 pm
by 6.5x61Super
Thanks Glen,
I will post pics + any results.
I see we are nearly "neighbors"!!
I live east of Mt. Vernon.
Re: I will be getting my new Remington XR-100 next week...
Posted: Sat Sep 13, 2008 4:37 pm
by Ruger No. 1
Heres a group from my load:
Only a 3 shot group
Re: I will be getting my new Remington XR-100 next week...
Posted: Sat Sep 13, 2008 8:19 pm
by Silverfox
I don't have a Rem XR-100, but I certainly like Remington 7½ primers in my Winchester casings and a stiff load of H4895 powder with the 39 gr. Sierra BlitzKing bullets. Ruger No. 1 seems to have found a very good load for his rifle. From Sierra's load data, that load 25.2 gr. of H4895 supposedly gives you around 3,400 fps. Is that about the velocity of your load Ruger No. 1?
Currently, I am using quite a bit
HOTTER load than that in my Savage 12VLP. It is over the recommended load in the Sierra load data, so if you intend to use H4895 and try to duplicate my load, start well under my load and work up slowly. Here's a 3-shot group from 100 yards off a concrete bench using a Harris bipod for the front rest and a rabbit-ear bag for the rear rest. When I shoot 5-shot groups, they are usually .500" or so.
You are going to enjoy that Rem XR-100. I have read lots of good reports on them. Post some targets when you get into your load testing phase.
Re: I will be getting my new Remington XR-100 next week...
Posted: Sat Sep 13, 2008 8:23 pm
by Ruger No. 1
Im not sure what exactly my loads are because I dont have a chrony. I actually switched to CCI 400 primers for this load and the groups opened up a little.
Re: I will be getting my new Remington XR-100 next week...
Posted: Mon Sep 15, 2008 5:46 pm
by Glen
You're Welcome.
How did you fair last night?? We lost power at 7:30PM & got it back this AM @ 6:10. Cable internet was also out til just a little bit ago. Quite a few trees uprooted here & laying on houses & garages & about 70 billion limbs on the ground too. All in all there was an estimated 200,000 out of power here & we had sent power trucks to Texas for Ike. Hope you all made it thru unscathed neighbor.
Re: I will be getting my new Remington XR-100 next week...
Posted: Tue Sep 16, 2008 6:56 pm
by 6.5x61Super
Wow...nice groups there!
If you guys get a chance..what was the COL on your loads.
The only reason I am asking is that I heard the XR-100's in 204 Ruger have relatively long throats.
Also, we were darn lucky NOT to lose electricity...I heard something like 2 million in Columbus lost power on Sunday.
Re: I will be getting my new Remington XR-100 next week...
Posted: Wed Sep 24, 2008 2:09 am
by 6.5x61Super