Finally finished - my new custom 204 - UPDATED
- Rick in Oregon
- Moderator
- Posts: 4942
- Joined: Thu Dec 01, 2005 4:20 pm
- .204 Ruger Guns: Sako 75V, Cooper MTV, Kimber 84M, Cust M700 11 Twist
- Location: High Desert of Central Oregon
- Contact:
Finally finished - my new custom 204 - UPDATED
After three months waiting for my barrel to be chambered and fit to my action, I just finished putting it all together.
This is the rifle that I mentioned earlier that would have the barrel cut with a 204 Ruger Match reamer from Dave Kiff at Pacific Tool & Gauge with a "no turn" .230" neck and 11 twist to best stabilize the 39 and 40 grainers. Details:
Pac-Nor Stainless Super Match 11 twist 3-groove barrel w/11 degree target crown @ 24" long (Remington Varmint Contour - .875" muzzle)
Blueprinted stainless Remington M700 Short Action w/Hi-Score single shot follower
Jewell HVR trigger w/safety
H-S Precision Stock w/full aluminum bedding block
Leupold VX-III 6.5-20X Long Range Scope w/Varmint Hunter Reticle and M1 Elevation Turret (30mm tube & 40mm Ovjective)
Sinclair Offset 30mm Scope Level
Now I need to get out to my range to break-in the barrel, sight in, and take it out next week with my Sako M75V 204R for a four day Skippy affair. I'll break it in with Remington factory 40 grainers, then use my Sako loads for the field, and work up a dedicated load and bed it with Accraglass when time permits.
Here she is in her virgin state; test fired by Pac-Nor only:
Looks like it just might work out....
The last thing Skippy will ever see......
Next time you see her, it will be under "204 Varmint Hunting". I predict Skippy will really hate this rifle......
This is the rifle that I mentioned earlier that would have the barrel cut with a 204 Ruger Match reamer from Dave Kiff at Pacific Tool & Gauge with a "no turn" .230" neck and 11 twist to best stabilize the 39 and 40 grainers. Details:
Pac-Nor Stainless Super Match 11 twist 3-groove barrel w/11 degree target crown @ 24" long (Remington Varmint Contour - .875" muzzle)
Blueprinted stainless Remington M700 Short Action w/Hi-Score single shot follower
Jewell HVR trigger w/safety
H-S Precision Stock w/full aluminum bedding block
Leupold VX-III 6.5-20X Long Range Scope w/Varmint Hunter Reticle and M1 Elevation Turret (30mm tube & 40mm Ovjective)
Sinclair Offset 30mm Scope Level
Now I need to get out to my range to break-in the barrel, sight in, and take it out next week with my Sako M75V 204R for a four day Skippy affair. I'll break it in with Remington factory 40 grainers, then use my Sako loads for the field, and work up a dedicated load and bed it with Accraglass when time permits.
Here she is in her virgin state; test fired by Pac-Nor only:
Looks like it just might work out....
The last thing Skippy will ever see......
Next time you see her, it will be under "204 Varmint Hunting". I predict Skippy will really hate this rifle......
Last edited by Rick in Oregon on Mon Apr 14, 2008 6:53 pm, edited 1 time in total.
-
- Junior Member
- Posts: 88
- Joined: Tue Feb 28, 2006 3:58 pm
- Location: Lake George, Colorado
Re: Finally finished - my new custom 204
Looks great Rick! I'm not real fond of black or dark colored stocks over on the eastern plains of Colorado in mid-July, but your rifle looks good.
Looking forward to the range report.
Mike
Looking forward to the range report.
Mike
Factory Custom
- Ray P
- Senior Member
- Posts: 645
- Joined: Sat Dec 31, 2005 10:32 am
- .204 Ruger Guns: 2-Rem 700 and Ruger#1 S/S
- Location: NE Pa
- Contact:
Re: Finally finished - my new custom 204
Rick.......nice, very nice and good luck with her. I sure she is in very good hands and you will teacher her well....................Look out Skippy!!
Let us know how the 11 twist works with the 40grn tips.
My 1-12 Harts are working very good with the 40's.
Good luck and thanks for the update. Can't have tooooo many 204's now can we!
Later
Ray P
Let us know how the 11 twist works with the 40grn tips.
My 1-12 Harts are working very good with the 40's.
Good luck and thanks for the update. Can't have tooooo many 204's now can we!
Later
Ray P
Life is an adventure and often to short. Make the most with family and friends. Shoot often and shoot a small hole. Love the 204 Ruger!! NRA Life Member
"We are never to old to learn"
"We are never to old to learn"
-
- Senior Member
- Posts: 1708
- Joined: Mon Sep 25, 2006 8:53 pm
- .204 Ruger Guns: 12FV, 12BVSS -S
- Location: Nebraska
Re: Finally finished - my new custom 204
Unreal...what a GREAT GIVEAWAY! Throw my name in the hat.
THANK YOU!
THANK YOU!
- Rick in Oregon
- Moderator
- Posts: 4942
- Joined: Thu Dec 01, 2005 4:20 pm
- .204 Ruger Guns: Sako 75V, Cooper MTV, Kimber 84M, Cust M700 11 Twist
- Location: High Desert of Central Oregon
- Contact:
Re: Finally finished - my new custom 204
scooter: Our season is done by July, so black in the sun is not an issue for me. Our ground rats are about done by the end of June; our last blast is our Annual Rat Rodeo down in N. Kalif in mid-June, then it's clean the rifles, work on them, or put them to bed until fall/predators. Thanks for the encouraging words though.
Ray P: Thanks for the kind words as always. I'll give her a through workout, you can be sure.
acloco: You funny guy!!!
Ray P: Thanks for the kind words as always. I'll give her a through workout, you can be sure.
acloco: You funny guy!!!
-
- Senior Member
- Posts: 281
- Joined: Sat Feb 18, 2006 8:09 am
- Location: s. w. Idaho
Re: Finally finished - my new custom 204
Is that a nick in the crown that I see? Very nice.
- glenn asher
- Senior Member
- Posts: 840
- Joined: Wed Feb 09, 2005 6:25 pm
- .204 Ruger Guns: Savage 12fvss, CZ 527 American
- Location: kentucky
- Contact:
Re: Finally finished - my new custom 204
Nice lookin' stick, Rick! Three months ain't bad, it could have been a lot worse. If you need someone to break it in, in a PD patch, I'm going out mid-June .
Build a man a fire, and he's warm for a day. Set a man on fire and he's warm for the rest of his life!
- Rick in Oregon
- Moderator
- Posts: 4942
- Joined: Thu Dec 01, 2005 4:20 pm
- .204 Ruger Guns: Sako 75V, Cooper MTV, Kimber 84M, Cust M700 11 Twist
- Location: High Desert of Central Oregon
- Contact:
Re: Finally finished - my new custom 204
WP: Nick indeed! But you did make me go back up to that pic to check it out.......
Glenn: Heck there buddy, by mid-June she'll be all broke in, will be down in N. Kalifornia for our Annual Rat Rodeo, and by then probably have at least 400 or 500 rounds down range....she'll be all broken in just fine....but thanks for the offer......yeah, right, what are friends for?
Glenn: Heck there buddy, by mid-June she'll be all broke in, will be down in N. Kalifornia for our Annual Rat Rodeo, and by then probably have at least 400 or 500 rounds down range....she'll be all broken in just fine....but thanks for the offer......yeah, right, what are friends for?
-
- Junior Member
- Posts: 88
- Joined: Sun May 01, 2005 6:49 am
- .204 Ruger Guns: Thompson Contender 23'' Bull BBL. Custom laminate Stock
- Location: Northeast Pa.
Re: Finally finished - my new custom 204
Hey Rick , Looking good man !!!!! Hope you have a ball !!! Watch-out VARMITS
-
- Junior Member
- Posts: 81
- Joined: Tue Jun 13, 2006 8:05 pm
- Location: Denver , CO
Re: Finally finished - my new custom 204
Rick,
Looks great. Watch out skippy there a new 204 in town. Let us know how that Pac-Nor shoots. I just had the gunsmith order the same barrel for my 20BR.
Looks great. Watch out skippy there a new 204 in town. Let us know how that Pac-Nor shoots. I just had the gunsmith order the same barrel for my 20BR.
204 try it you'll like it!
- Sidewinderwa
- Senior Member
- Posts: 648
- Joined: Mon Dec 26, 2005 9:39 am
- .204 Ruger Guns: Savages
- Location: Washington state
Re: Finally finished - my new custom 204
Oh man, sorry that it turned out that way. I can see why you are going to Kalifornia, to try to palm it off on some uneducated Kalifornian. OK I'll trade it straight across for a Crossman pellet gun and a card table to shoot it off of.
Great looking rat rifle. Be sure to take lots of pictures of it in action.
Great looking rat rifle. Be sure to take lots of pictures of it in action.
Please, no Sidewinder today!
- Captqc
- Senior Member
- Posts: 1036
- Joined: Fri Feb 02, 2007 3:09 pm
- .204 Ruger Guns: Cooper Phoenix .204
- Location: Tigard, OR.
Re: Finally finished - my new custom 204
Sidewinder, sorry man but you're too late, Rick has already agreed to trade my factory 700 for that sorry thrown together bang stick. I figured it's the least I could do for a good friend! Gary
- Glen
- Moderator
- Posts: 1741
- Joined: Sun Feb 06, 2005 9:22 pm
- .204 Ruger Guns: Rem700ADL
- Location: New Philadelphia, Ohio
- Contact:
Re: Finally finished - my new custom 204
Nice lookin rig you got the Rick!! Congratulations on the build & I hope she shoots lights out for you!!
Friends Are Friends By Nature.
RIP Russ,Blaine, & Darrell!!
I don't like repeat offenders. I like DEAD offenders!!
Ted Nugent
Isn't there a minimum age for grampas??
^^^^^^
Audrey Renae told me "No there isn't"!!
Glen
RIP Russ,Blaine, & Darrell!!
I don't like repeat offenders. I like DEAD offenders!!
Ted Nugent
Isn't there a minimum age for grampas??
^^^^^^
Audrey Renae told me "No there isn't"!!
Glen
- Silverfox
- Senior Member
- Posts: 937
- Joined: Tue Feb 01, 2005 1:51 pm
- .204 Ruger Guns: Savage 12VLP purchased in June 2004 + 2 other custom .204s
- Location: NW North Dakota
Re: Finally finished - my new custom 204
That is one sweet looking setup Rick!!! You got me drooling all over the keyboard!!!! I'll be waiting by my computer screen to see some targets and reports on what powder, etc. are working for you.
Sage Rats--Your Worst Nightmare Is About to Come to Fruition!!!!!
Sage Rats--Your Worst Nightmare Is About to Come to Fruition!!!!!
Catch ya L8R--Silverfox
Re: Finally finished - my new custom 204
Looking forward to a range report/rat report!