Page 1 of 1
TC Dimension won't extract/eject
Posted: Fri Oct 02, 2015 8:42 am
by Dans58
I just purchased a new Dimension in .204 Ruger. The gun will not extract any spent cartidge . I'm shooting factory load Hornady 32Gr. TC said that I shouuld send the gun back to the, but Coyote season just opened here and I don't want to lose the gun for an extended period. Has anyone else had this problem? Would a new Bolt work ? Thanks for advice. Dan S.
Re: TC Dimension won't extract/eject
Posted: Fri Oct 02, 2015 10:04 am
by oldfox
Sounds to me like a bad extractor... check with a local gunsmith. Should not be a difficult job to replace..
Re: TC Dimension won't extract/eject
Posted: Fri Oct 02, 2015 10:25 am
by Bill K
oldfox wrote:Sounds to me like a bad extractor... check with a local gunsmith. Should not be a difficult job to replace..
Agree, bet your local smith could solve the problem pretty fast. Bill K
Re: TC Dimension won't extract/eject
Posted: Wed Nov 18, 2015 7:51 am
by Dans58
UPDATE: it was a bad extractor on the bolt. All is well now, shooting great.