SmallCaliberCentral

I have a Br Pivot with the plastic top and made a wood top out of 3/4 Birch Plywood.. I have the dimensions, but need to know where to drill the hole for the center post assy... I guess I didn't drill the 1st one in the right place...

Denio, please tell me which measurements you need and I'll be happy to take them from my wood top.

Mike, I just need the distance from the front edge of the top to where the 1st holes are drilled, and then from the holes to the right edge...
I drilled mine too close to the front... just doesn't feel right... Thanks...

I just need one hole (same one) measured to the front edge and then to the right edge...

Sorry for the delayed response, Denio. I'll take those measurements this evening for you.

Here are some pictures that I hope will help. All are taken with the bottom of the table facing up.

http://flic.kr/p/eJQmMr


From left edge of the table:


From right edge of the table:


From front edge of the table:


Width of mounting plate (left to right):


Length of mounting plate (front to back):


If you need any other shots or have questions about the ones I posted, please let me know.

Mike

Here are some pictures that I hope will help. All are taken with the bottom of the table facing up.


From left edge of the table:

http://www.flickr.com/photos/92543431@N02/9017342137/

From right edge of the table:

http://www.flickr.com/photos/92543431@N02/9017348761

From front edge of the table:

http://www.flickr.com/photos/92543431@N02/9018523316

Width of mounting plate (left to right):

http://www.flickr.com/photos/92543431@N02/9017366107

Length of mounting plate (front to back):

http://www.flickr.com/photos/92543431@N02/9017362661

If you need any other shots or have questions about the ones I posted, please let me know.

Mike

Thanks Mike... I was off a little... Extra holes drilled into the top will give it a little patina..
$170.00 plus shipping for a new one was a good reason to build my own... Thanks again... Jim

My pleasure, Jim.