SmallCaliberCentral

just purchased a new scope for my cz 527,204.Its 30mm and my rings are 1".The only ring that I could find IN STOCK were Millet .I don't know anything about millet. any advice here. Thanks ,Dan

Their scopes and rings appear to be of good quality.. Bill K

From years of experience, I'd rank Millet at the lower end of the quality spectrum in the world of optics mounts....not bad mind you, just not tip-top.

If you're interested, I've got a brand new in the box set of Leupold blue Medium 1" rings for a CZ 527, never been opened. PM me for deal-o-the-day price.

Thanks Rick But I have 1" rings but need 30mm.Other than Millet and Leupold who else makes cz rings?

Warne also make 30mm rings for the CZ527

TrapperDan wrote:Thanks Rick But I have 1" rings but need 30mm.Other than Millet and Leupold who else makes cz rings?

The best I've found to date are from James Calhoon. His "Hunker" rings are beefy, and allow the scope a full .125" lower if wanted over regular "Medium" height rings and available in both 1" and 30mm. I've got them on my CZ 527 American in 221FB with a Lupy VX-2 4-12X 40mm, and the scope is nice 'n low over the bore for an excellent cheek weld. Tip-top in my book.



http://www.jamescalhoon.com/pricelist.php

Thumbs down for me on the millet. For some reason, the head of the ring (not base) screws was given very little bearing surface on a set that I had, and with not much effort (no, I did not use a torque wrench but Millet did not provide a spec...) the head of at least one screw actually squeaked THROUGH the upper ring a little.

One bad experience did scare me off them

Weaver tactical for me...

.. or Tally (Talley?)