TC Dimension won't extract/eject
-
Dans58
- New Member
- Posts: 2
- Joined: Tue Sep 29, 2015 2:19 pm
- .204 Ruger Guns: TC Contender, TC Dimensions
TC Dimension won't extract/eject
I just purchased a new Dimension in .204 Ruger. The gun will not extract any spent cartidge . I'm shooting factory load Hornady 32Gr. TC said that I shouuld send the gun back to the, but Coyote season just opened here and I don't want to lose the gun for an extended period. Has anyone else had this problem? Would a new Bolt work ? Thanks for advice. Dan S.
-
oldfox
- New Member
- Posts: 45
- Joined: Wed Jan 14, 2015 4:30 am
- .204 Ruger Guns: Ruger American Predator
- Location: Maine
Re: TC Dimension won't extract/eject
Sounds to me like a bad extractor... check with a local gunsmith. Should not be a difficult job to replace..
-
Bill K
- Senior Member
- Posts: 2324
- Joined: Tue Jan 18, 2011 10:00 am
- .204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
- Location: Lake Forest, Ca.
Re: TC Dimension won't extract/eject
Agree, bet your local smith could solve the problem pretty fast. Bill Koldfox wrote:Sounds to me like a bad extractor... check with a local gunsmith. Should not be a difficult job to replace..
-
Dans58
- New Member
- Posts: 2
- Joined: Tue Sep 29, 2015 2:19 pm
- .204 Ruger Guns: TC Contender, TC Dimensions
Re: TC Dimension won't extract/eject
UPDATE: it was a bad extractor on the bolt. All is well now, shooting great.