Page 1 of 1

AR15 in 204 Ruger "SOLD"

Posted: Tue Oct 19, 2010 5:33 pm
by pipedoctor
This is a custom built 204 Ruger, the barrel is fluted, 24 inches long, 1 in 12 twist, by DPMS. They say the barrel is optimized for 32 grain bullets. The lower is a forged piece by Double Star, the bolt carrier group is Rock River Arms, The upper is a forged flat top, forward assist, don't remember where I got it. The scope is a BSA Cats-eye, 6x24 power, adjustable objective lens, fine duplex post reticule, Weaver see thru rings. There are some ring marks on the tube, as I had it mounted too far back, and had to move it forward. Trigger group is standard DPMS, as are the internal parts. I have shot it a few times, maybe 40 rounds, and it shot great. The free float for-end is vented, two piece. Standard trap door but stock. One 20 round magazine. This was to be my walking rig, but I can't walk much anymore, so it has to go. Weighs just under 10 pounds, empty. Asking 800.00 for it.
Not sure about shipping anymore. Some places will only deal FFL to FFL, so whatever I have to pay for shipping, is what you pay. I don't try to make money off the freight!!! At any rate, will only ship to an FFL holder.
Thanks for looking
Wayne
pipedoctor@msn.com





These are the pictures:
Image
Image
Image
Image

Re: AR15 in 204 Ruger

Posted: Tue Oct 19, 2010 9:07 pm
by Captqc
Wayne, if you haven't already, post this on the NorthWestFirearms.com forum. I've had good luck selling on that site. Gary

Re: AR15 in 204 Ruger

Posted: Wed Oct 20, 2010 10:30 am
by pipedoctor
Thanks for the info. I listed it there. Did not know that site was there. Thank You!!
Wayne