WTS a Bruno's Shooters Supply 6PPC neck size shoulder bump back die. This is a threaded die, for standard 7/8-14 presses. This die uses Wilson/Redding bushings, and pushes the shoulder back. I did one modification to it, I cut a slot in the top of the decaping pin so that a flat tipped screw driver could be used to turn the stem up and down. Die has a light bruise mark on the knurled section, from loosing and tightening top.
Part number BRUNO-SB
Sells new for $125.00
http://www.brunoshooters.com/Merchant2/ ... e=BRUNO-SB
Asking $70 shipped, (OBO) will only ship inside the USA. No bushings included. Will accept Pay pal with a 5% addition fee. Would consider trades of 30BR stuff, (Dies, brass, bullets, neck bushings, Sinclair expanders) Bolt holster, or other benchrest equipment.
