reticles for target shooting

Hutch20 · Post by **Hutch20** » Wed Jul 11, 2007 8:25 pm

I'm lookin to pick up a scope just for the purpose of working up a load.
what would work better a target dot or mil-dot. That the only chioce I've been given in the scope I'm gonna get.

Thanks

Hutch

Vartarg · Post by **Vartarg** » Thu Jul 12, 2007 4:34 am

Fine Cross Hair......

Hotshot · Post by **Hotshot** » Thu Jul 12, 2007 1:10 pm

Hutch20,

When I'm doing some serious load testing I put on an 8-32 with 1/4 inch target dot. My aim points are 1/4 inch squares at 100 yards. Over many years of shooting I firmly believe this is the best way to get good groups. Everything is minimal as far as reticle and aim point which makes it easy to concentrate on the job at hand, putting your bullets in the same hole. This works for me and several of my shooting buddies who have tried this same logic. When I have satisfactory loads I remove the monster scope and put on one more usable in the field(4.5-14 or 6.5-20).

Hawkeye Joe · Post by **Hawkeye Joe** » Thu Jul 12, 2007 6:14 pm

Hutch 20
I just picked up a 35X45 Leupold Comp with target dot.I didn't think I would like it. Actually made plans to have a Fine Crosshair reticle installed this winter. After a month of use plans have changed. I kinda like that little dot

skipper · Post by **skipper** » Thu Jul 12, 2007 7:32 pm

I like having extra fine crosshairs for target work. There are less distractions to contend with. The extra fine crosshairs make lining up the lines on the target and the crosshairs easier. This will aid in keeping you from canting the rifle while shooting for groups. I paid an extra $150 dollars to have the CH-3 reticle installed on my NightForce. Look at the picture below. The Mil Dot reticle is way too busy for target work and the crosshairs are too thick to use for lining up with the horizontal and verticle lines on the target.

Hutch20 · Post by **Hutch20** » Thu Jul 12, 2007 7:54 pm

Thanks guys.

The scope I'm lookin at is the BSA platinum, either 6-24, or 8-32. The target dot reticles are fine cross hairs with 1/8 MOA dot, that should be a small enough dot for target work.

Again, thanks for the input. You guys are top shelf

Hutch

skipper · Post by **skipper** » Fri Jul 13, 2007 4:21 am

That CH-3 reticle actually has a floating super fine dot right in the middle. The crosshairs dont actually touch in the middle. They frame the super fine dot. The picture isn't a high enough resolution to see it. A 1/8 MOA dot is going to cover up a lot of bullseye at 100 yards.

LeeC · Post by **LeeC** » Fri Jul 13, 2007 6:26 am

"BSA" stands for "Buy Some Alternative" in my opinion.

Hutch20 · Post by **Hutch20** » Fri Jul 13, 2007 4:52 pm

LeeC, I was asking opinion's about reticles. I don't give a darn about your opinion on what I spend MY money on thank you.

Skipper, I thought CH-3 looked like what you described, actually I couldn't see the dot

. How big is the dot in the CH-2 reticle?

Hutch

skipper · Post by **skipper** » Sat Jul 14, 2007 5:50 am

Hucth20

I had to go look that up. Here's what the brochure said:

Designed for long range, high power competition, the CH-2 features a .200 M.O.A. dot on a .030 M.O.A. crosshair when measured at 22x. This .200 M.O.A. dot is calibrated for scored shooting on standard NRA high power competition targets.

tarbabi · Post by **tarbabi** » Fri Aug 31, 2007 3:45 pm

I am using the Nightforce NP-1RR and absolutely love it.

SmallCaliberCentral

reticles for target shooting

reticles for target shooting

FCH

Re: reticles for target shooting