Page 1 of 1
I goofed, but then again I didn't.
Posted: Wed Nov 07, 2007 1:42 pm
by Ohlsen
I had a few custom .20 cal bullets sent to me, so I pulled some .20 Tac rds that I wasn't interested in shooting. I grabbed the dies and ran the rds thru the neck sizer. When I got around to loading these I notice only about 3/32" or so of the neck was sized. Picked up the box of dies and found out I had used my .204 Ruger neck die. I loaded them, worked good, may try this again.
Tom
Re: I goofed, but then again I didn't.
Posted: Wed Nov 07, 2007 2:21 pm
by acloco
Nothing wrong with that. You just neck sized...but with a set of dies from a 204 instead of a Tac 20
Re: I goofed, but then again I didn't.
Posted: Wed Nov 07, 2007 2:43 pm
by jo191145
No goof I've done that on purpose.
Amazing accuracy is possible by eliminating as much neck tension variations as possible.
For me the ES's went through the roof but I did'nt seem to notice on paper at 100-200 yards.
Further out I'm sure it would bite you.