Opinions on handloading new brass-

Ask questions and share information about reloading.
Bill K
Senior Member
Posts: 2324
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Opinions on handloading new brass-

Post by Bill K »

Speer ? Or do you mean Berger ?
K22
Junior Member
Posts: 72
Joined: Sat Apr 13, 2019 3:54 am
.204 Ruger Guns: Kimber

Re: Opinions on handloading new brass-

Post by K22 »

Bill K wrote: Sat Dec 11, 2021 8:42 am Speer ? Or do you mean Berger ?

Oh boy. It's obvious I can't read. I saw a yellow box and read Speer, but I see that his box is Berger. :oops:
Huskerguy
New Member
Posts: 6
Joined: Tue Jul 13, 2021 5:45 pm
.204 Ruger Guns: Savage Model 25 Varminter

Re: Opinions on handloading new brass-

Post by Huskerguy »

To take this in a slightly different direction, I purchased some primed Fiocchi for the .204 that had the bullets pulled. The brass looks good, no marks, nice and clean and I checked neck tension with a bullet and it was tight to seat. That's not to say they are all that way. My original plan was to remove my depriming pin and size them just to make sure. And I did measure some at the base and neck and the neck is dead on and even just slightly under specs.
Post Reply