Re: What Primers
Posted: Wed Dec 19, 2007 3:18 am
Check the Midway site again. It says "Out of Stock,No Backorder". If you can still find it I would grab as much as you can.
The dies you have may do the job. I would load a few and see how they turn out. Check the run out to see if they will produce acceptable loads.
If you go the custom die route. I would get a Body Die for sizing new brass and bumping the shoulders back. A Bushing Neck Sizing Die for sizing your case necks between firings and a Micrometer Top Seating Die. Like jo191145 said, if you can get a hold of the reamer used on your chamber, that would make it possible to have dies made that perfectly match your rifle.
The dies you have may do the job. I would load a few and see how they turn out. Check the run out to see if they will produce acceptable loads.
If you go the custom die route. I would get a Body Die for sizing new brass and bumping the shoulders back. A Bushing Neck Sizing Die for sizing your case necks between firings and a Micrometer Top Seating Die. Like jo191145 said, if you can get a hold of the reamer used on your chamber, that would make it possible to have dies made that perfectly match your rifle.