Friends,
Can a 20VT Redding Type S Bushing Neck Sizer die be used to resize 204 Ruger as well? Seems like it would if properly adjusted, given the relative length of the two cases.
Thanks,
Dan
Question about Bushing Sizing Dies
-
wirelessguy2005
- Senior Member
- Posts: 663
- Joined: Wed Feb 24, 2010 6:59 pm
- .204 Ruger Guns: Custom 20 SCC, Savage LRPV 20 Nitro , Howa 1500 204 Ruger
- Location: Indiana
Re: Question about Bushing Sizing Dies
Dan,
That will work just fine for neck sizing as long as you adjust the die up in the press the appropriate distance.
Brad
That will work just fine for neck sizing as long as you adjust the die up in the press the appropriate distance.
Brad
-
Nor Cal Mikie
- Junior Member
- Posts: 70
- Joined: Wed Apr 25, 2012 8:25 pm
- .204 Ruger Guns: None. Had a 16" barreled rear grip SP that was WAY too wild.
- Location: 150 miles North of San Francisco
Re: Question about Bushing Sizing Dies
The neck area will get sized with no problem but somewhere down the road the case body may need to be full length resized or stiff bolt closing may be an issue.
-
Gleedaniel13
- New Member
- Posts: 20
- Joined: Sun Jun 16, 2013 9:18 pm
- .204 Ruger Guns: none
- Contact:
Re: Question about Bushing Sizing Dies
Same here, I think the neck resizing won't affect but the other parts that will be taken will be another issue. Just careful in resizing to have balance on your thing.The neck area will get sized with no problem but somewhere down the road the case body may need to be full length resized or stiff bolt closing may be an issue.
