SmallCaliberCentral

Looking for a 20 cal barrel blank, 1-10 or 1-11 twist-
#3 up to #5 contour- let me know if you have one or if you know where to find one,
thanks

Well I got out once more to try the 39sbk and a few more 40gr noslers, I think I am going to give up on the 40s for now and stick to the 39sbks, I just can’t get the 40s to shoot under 2” groups, I haven’t tried any other powder with it other than h4895, but the 39s are shooting good, in my last tes...

Finally got back out and shot a few of the 39gr
Sierra BlitzKings, with the h4895, the groups were quite a bit better than the 40gr Noslers, going to work a little more with a few of these loads, and see what happens, and maybe try the noslers a bit more.

Okay, I understand but let me rephrase my question so I am on the same page, if you have 2 loads of different charges made up with the same seating depth, and group A shoots a little better than group B, isn’t it possibly that group B may shoot better than group A with a different seating depth, or ...

One question on bullet seating depth, when I seated these I went out just about as far as I could, when doing a load development should one start the loads in at what the book says then work out? I know it will more than likely change your groups, but is it possibly for some charges to shoot better ...

Sounds good, I will have to invest in a set of Redding dies, what is the model to get for the 204?

What is run out? And what is the best neck resizer to buy or what do you recommend, will have to order it as there is nothing in my town.
Thanks

I am using a RCBS full length resizing die, I have thought about buying a neck resizing die to try since all of the brass has come from my gun?, the oal I was curious about, I have them out about as far as I can and still fit in my mag, maybe can get a little longer, I havent tried them them seated ...

Hi, I am new to the forum and have been shooting my stock 204 Remington sps with bell and Carlson stock, vx3 4.5-15 Leopold for about 5 years and just now starting to get into reloading, and would like some help and input, I have read extensively on all the loads and twist and bullets so I am famili...