SmallCaliberCentral

Hi Folks

I can't seem to find much information about this particular Cooper. From what I gather it is a lightweight varminter style. Anyone own one? Does anyone know if they do it in a left hand model 21??

Thanks
Matt

Mate those Nosler 150gr B/T's are brilliant in my 7mm Rem mag. My pet load is 63.4gr of Re-22. Very very accurate.

EXACTLY WHICH CALIBRE WERE YOU USING AGAIN???

I showed these pictures to some workmates and they won't beleive that a .204 could do this

I'm in Australia and am in the process of ordering a Montana Varminter. Getting a Cooper here is somewhat a bit of a task and is probably going to take 6 months or more, perhaps I should get a Mickey Mouse timber upgrade....approx. what is the extra cost to go to the AAA select timber??

That is a darn fine looking Cooper. Does that have a timber upgrade?

doubleA wrote:

I've only just seen the first of the Tikka .204's land here in OZ. Very surprised that we got a supply of them before you folks in the states. However I never saw a SAKO 75 in .204, and for that matter am yet to see an 85 model varminter at all..

Hi folks Well thanks to all the advice I've got myself a K&M .20 cal deburring tool. Now I've got a question....is it possible to "over" debur the flashhole? I've been using this tool on my factory fired Hornady brass and it seems to remove alot of brass compare to my other tool I use ...

Thanks for the link. I'll check it out. Problem might be -> I'm in Australia mate...

All I've seen down here is these two products....though I have heard of some folks ordering stuff from sinclairs international.

Hi folks

I've been using factory fired Hornady brass and I'm just wondering what tool you can use to debur the flashholes? I normally use a forster unit to do other cals but she only goes down .22cal. Same goes for the Lyman...