SmallCaliberCentral

Winchester hasn't produced stand alone .204 brass since around 2013ish

Check out MDT mags, they make a polymer AICs mag that'll work .204 and they are priced cheaper than the steel mags. I'm sure Magpul will eventually get to making .223 mags in the AICs system

Hopefully Magpul starts making their AICs PMAGs in 5rd 223. I haven't found anybody making them yet which is disappointing. Curious what your smith did to the follower, have any pictures?

savageboy23-- Send them a letter and enclose a photo of the casing. You might find a bag of 100 new casings in your mailbox shortly after they inspect the photo. Then again, you may not get anything, but it is good for them to know their quality control inspections aren't working 100%. Silver fox I...

Let us know how this works out, rifle looks interesting. What did it cost you out the door?

I seen on another sight that someone asked Berger and they said they were going to tool up and run more in January. Whether that's true or not is unknown, Midway still shows them on their page as out of stock, no back order

Powder valley was also showing in stock on 500rd boxes last night.

500 count boxes available right now on midway

Thanks twentybore

I picked up a set of used Redding series A dies for my .204 a few days ago and they didn't come with a set of instructions, does anybody have these in a PDF form or can point me in a direction other than Redding? They are shut down for a company vacation until the 12th so if all else fails I'll just...

Can you even load those bullets to mag length without the ogive being in the case? I loaded them for single shot use in a 1in8 twist 24" AR, if I remember correctly they liked to be out close to the lands

I stuck my Lee decapping rod in the drill press and turned more of a taper on the main shaft so it doesn't catch on case mouths any more, works great now.