SmallCaliberCentral

I just ran a 100 rounds through my Remington 700 SPS at squirrels in Northern Calif. this past weekend and they worked as well if not a little better upon impact,lots of parts flying through the air,dynamic expansion!
scratch1

I have just started experining small slivers of brass falling on my loader upon seating the bullet,this just started happening. My bullet seater die is tight so nothing has slipped.Any information as to the cause would be helpful. This is .204 caliber and RCBS dies. It does it with Nosler Ballistic ...

Thank you everyone for your response,thats a good starting point.

any loads for the berger 35 grain match varmit bullet in 204?

has anyone got a load for this bullet? I cannot find any data other than 40 and 50 grain

I know there is a shortage of Primers but does anybody have any knowledge of a supply house that still has some that would share with fellow members. Rat season has started !!
Scratch 1

Does anyone have Loads for the 26 grain Barnes Varmit Grenade in .204?? They are very new to the market in .204 ruger, I have a box of 100 but did not know where to start?
Any real loads out there that can be published?
Scratch1

Rick,
Thanks for the heads up on the manual,
Scratch

Has anyone got a load for the 26 grain Barnes Varmit Grenade that they may publish?
Have the bullets but no knowned loads available.
This is a great site and I am fairly new to it.

New member looking for some posts that were in here a few days ago,but cannot find them?
Barnes 26 gr loads.
Is there a short cut to eariler posts